Parts Cane Creek Helm Mark II Limited Edition Tan Air Sprung Fork

The original Helm fork impressed many riders with its stiff chassis, supportive feel, and a host of innovative features. It was a fork that liked it rough and performed best at high speeds under hard-charging riders.

The Mark II retains many of the great features of the original Helm, but Cane Creek has tweaked, tuned, and improved the damper and air spring to create a fork with the ideal balance of buttery smoothness and support.

This listing is for the limited edition Tan coloured model. Get it while it’s hot!

Features:

• Lighter compression tune to improve sensitivity
• New SKF low friction seals
• 2.5wt Motorex damper oil with 11% lower viscosity
• New friction-reducing air spring material
• Increased air volume for better traction and suppleness
• New threadless air seal head for easier travel change

Who this for? The Helm is best suited for Trail/All Mountain riding and Enduro racing.

Spring type: This fork uses a manually equalised air spring. This differs from most other forks in that you will need to equalise the positive and negative air springs by pressing a release valve at the base of the fork. This requires an extra step in the setup process but it does provide you with extra potential to tune the fork to your liking by varying the pressure between the two air springs.

Wheel size compatibility: 29″ wheels.

Weight: 2080g

Fork offset: 44mm

Axle to crown height: Measured at 160mm (varies according to set length of travel)

• 29: 573mm

Max tyre width:

• 29: 2.5″

Suspension travel amount: Factory set at 160mm

• Internally adjustable between 130mm and 160mm

Compression damper style technologies / adjustments: The MKII features a new compression and mid-valve circuit for increased support and control. A new SKF oil seal head and lighter weight damper oil reduce friction and provide a more supple ride feel.

• High-speed compression (10 clicks)
• Low-speed compression (17 clicks)

Rebound damper technologies / adjustments:

• Low-speed rebound (10 clicks)

Travel adjustability: Travel is internally adjustable in 10mm increments by adding or removing travel spacers. 2 Travel spacers included

Volume adjustability: Air volume can be changed internally without the need for spacers via an indexed 8 position air volume adjustment system.

Stanchion diameter: 35mm

Axle size and style: The fork uses Cane Creek’s “D-Loc” axle system. 15mm Bolt-on thru-axle. 15mm x 110 BOOST spacing

Steerer tube standard: Standard 1.5″ to 1 1 1/8″ taper

Brake mount style: (and size): 180mm post mount

Brake rotor compatibility (minimum / maximum):

• Minimum: 180mm
• Maximum: Not stated.
• If you are using a Hope Tech brake on a Helm fork, you will need to use a 200mm rotor with the appropriate adaptor.